Werbung
BRIZA JDPC.001 Dynamic Product Controller
1. Turn off power
• press and hold both "-" and "+" buttons simultaneously.
2.
Turn power on. Press and hold both "-" and "+" buttons simultaneously until the
3.
The controller will return to Factory Default settings, all LEDs will flash for 8 "
Attention: Doing so will erase all of the data, settings, and applications and reset the controller to the original factory settings !!
Warning
This product is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the product.
Please follow these instructions carefully in order to allow for an error-free installation and a carefree use.
30
Reset to Factory Default
blue LED light
is blinking. After 2 "the
green LED
Entitlement to warranty is cancelled in case of:
• errors or damage resulting from not following the assembly, cleaning or user instructions supplied by
the manufacturer,
• wrong, improper and/or irresponsible use or treatment of the device,
• wrong or incompetent repairs and defects due to external factors,
• self-applied changes to the device.
• equipment that is built in, in a way that it cannot be reached normally.
If you have any questions or complaints, please contact your supplier or installer.
The copyright of these instructions is the property of the company Jaga Inc.
will light and then after 4", the
red
LED.
27200.24100011 - October 5, 2015 3:14 PM - Jaga N.V.
Werbung
