Werbung
BRIZA JDPC.001 Dynamic Product Controller, mounting control panel
Clean the surface on which the panel is mounted.
a. plug in the control panel
b. remove the protective film from the tape
c. attach the control panel using the tape
BRIZA JDPC.BRC3 Dynamic Product Controller,
With room-temperature sensor and water-temperature sensor
0
Basic settings JDPC.001: MODE C
Configuration code: see the product label on the device
Setup and operation
The module is factory assembled and tested according to the product configuration.
Basic settings water temperature set point:
Operation:
Mode koelen
Mode cooling
WT°<RT°-4°
WT°>RT°-2°
WT° = Watertemperatuur
WT° = water temperature
RT° = Ruimtetemperatuur
RT° = room temperature
Fan start when supply water T° <19°C
Auto mode
Mode verwarmen
Mode heating
Standby
WT°<RT°+2°
WT°>RT°+4°
Fan start when supply water T° >32°C
Control panel mounting
a
b
heating
and
Ι
Ι
Ι
Not connected
BLUE -24V
RED +24V
Manually adjusting settings:
Adjusting fan speed
Adjusting water temperature set
point
cooling.
Connecting
Table 1A: fan speed
Table 2: adjusting min. water temperature
Table 3: adjusting max. water temperature
c
Page
6
heating
7
cooling
25
Werbung
