Automatic Switch-Off; The Heat Setting; Bridge Function; Automatic Heat Up - Electrolux EHI6740F9K Benutzerinformation

www.electrolux.com
8
4.2 Automatic Switch Off
The function deactivates the
appliance automatically if:
• All cooking zones are deactivated (
).
• You do not set the heat setting after
you activate the appliance.
• You spill something or put something
on the control panel for more than 10
seconds, (a pan, a cloth, etc.). An
acoustic signal sounds some time and
the appliance deactivates. Remove the
object or clean the control panel.
• The appliance becomes too hot (e.g.
when, a saucepan boils dry). Before
you use the appliance again, wait for
the cooking zone to cool down.
• You use incorrect cookware. The sym-
bol
deactivates automatically after 2 mi-
nutes.
• You do not deactivate a cooking zone
or change the heat setting. After some
time
deactivates. See below.
• The relation between heat setting and
times of the Automatic Switch Off func-
tion:
•
,
•
-
•
-
•

4.3 The heat setting

Touch the control bar at the heat setting.
Change clockwise or counterclockwise, if
it is necessary. Do not release before you
have a correct heat setting. The display
shows the heat setting.
comes on and the cooking zone
comes on and the appliance
- — 6 hours
— 5 hours
— 4 hours
- — 1.5 hours

4.4 Bridge function

The Bridge function connects two cook-
ing zones and they operate as one.
First set the heat setting for one of the
cooking zone.
To activate the Bridge function touch
To set or change the heat setting touch
one of the control sensors.
To deactivate the Bridge function touch
. The cooking zones operate inde-
pendently.

4.5 Automatic Heat Up

You can get a necessary heat setting in a
shorter time if you activate the Automatic
Heat Up function. This function sets the
highest heat setting for some time (see
the diagram), and then decreases to the
necessary heat setting.
To start the Automatic Heat Up function
for a cooking zone:
1.
Touch ( comes on in the dis-
play).
2.
Immediately touch the necessary heat
setting. After 5 seconds
in the display.
To stop the function change the heat set-
ting.
12
11
10
9
8
7
6
5
4
3
2
1
0
1 2 3 4 5 6 7 8 9 10 11 12 13 14

4.6 Power function

The Power function makes more power
available to the induction cooking zones.
The Power function can be activated for a
limited period of time ( see Technical In-
formation chapter). After that, the induc-
tion cooking zone automatically sets back
to highest heat setting. To activate, touch
, comes on. To deactivate, change
the heat setting.
.
comes on