Installation - IKEA Renlig IWM60 Handbuch

ENGLISH
Average annual energy con-
2)
sumption (kWh)
Average annual water con-
2)
sumption (litres)
1) If the pressure in your area is lower or higher, please contact your After Sales Service.
2) The data is based on the washing programme for test institutes assuming 200 cycles per a year.
Information on the electrical connection, voltage and overall power is given on the rating
plate, on the inner edge of the appliance door.

Installation

Caution! Refer to the assembly
instructions, in order to proceed with the
installation.
Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Place the appliance on the floor and install it
under a counter (kitchen worktop or sink).
If a repair is necessary, the appliance must be
easily accessible for the engineer. Put the ap-
pliance adjacent to a water tap and a drain.
For the venting of the appliance only water fill,
water drain and power supply cable openings
are necessary.
Water inlet
1
204
9000
Connect the hose to a
tap with 3/4" thread.
2
35° 45°
Caution! Do not place the inlet hose
downwards.
The inlet hose must not be lengthened. If
it is too short and you do not wish to move
the tap, you will have to purchase a new, lon-
ger hose specially designed for this type of use.
Water drainage
Caution! Make sure that the water cou-
plings are tight to prevent water leak-
age.
Turn the inlet hose to
the left or the right to
suit the installation.
Tight the locknut cor-
rectly to prevent wa-
ter leaks.
If you connect the
water drain hose to a
water trap under the
A
sink, remove
plastic membrane
(A). If you do not re-
move the membrane,
detergent residue
and clothes fluff can
cause a blockage in
the drain hose spigot.
21
the