Logger; Preparing A Logger Process; Setting Test Item 1 - WIKA CPH7000 Betriebsanleitung

6. Commissioning, operation
6.5

Logger

Press the [Logger] app to go to the logger function.
This function allows up to three different test items to be measured and displayed simultaneously.
EN 1. Press app [Logger].
⇒
The [Logger] application window is displayed.
+
2. Press button [ ]
⇒
The new logger process can be started.

6.5.1 Preparing a logger process

To avoid inconsistencies during data acquisition, it is necessary to observe the sequence of test items 1, 2 and 3.
In order to carry out the logger process, test item 1 must always be entered in the first field. The other test items
must then be entered in the second and in the last field.

6.5.1.1 Setting test item 1

1. Press button .
1
⇒
The selection window of the possible types of test item is displayed.
⇒
You can choose between: INT, EXT1
mA , mA 24V, GAU
Out Out
⇒
Display shows the pin assignment.
2
⇒
Display shows that the CPH7000 is in the setting mode.
3
2. Select type of test item.
⇒
Return to the menu screen.
1) Displayed only if an external sensor is connected.
Selecting the type of pressure
3. Press button .
4
4. Select type of pressure (rel. or abs.).
⇒
If a barometric reference is installed in the CPH7000, it is possible to switch between rel. and abs. The CPH7000
calculates the respective pressure value from the values of the barometer.
Selecting the pressure unit
5. Press button .
5
⇒
The selection window of the possible pressure units is displayed.
6. Select pressure unit.
⇒
Return to the menu screen.
Zero point setting
6
7. Press button .
6
⇒
A numeric keypad will be displayed.
8. Adjust the zero point
9. Confirm with [OK].
⇒
Return to the menu screen.
44
1) 1)
, EXT2 , mA
1) 1) 1)
, DIFF, AMB , RTD switch test, switch test
4
5
WIKA operating instructions portable process calibrator, model CPH7000
, mA 24V, V , V 24V,
IN IN IN IN
, [---]
24V
1
2 3
6 5 4