Water Drain Connection - AEG F77009W0P Benutzerinformation

24
Installation
How to remove the appliance worktop
1. Remove the rear screws (1).
2. Pull the worktop from the behind of the
appliance (2).
3. Lift the worktop and move it from the
front slots (3).
4. Use the adjustable feet to adjust the level
of the appliance.
5. Install the appliance under the kitchen
worktop. Do not squash or bend the wa-
ter hoses during the installation.
To adjust the level of the appliance
A correct level of the appliance lets the door to close and seal correctly.
With an incorrect appliance level, the door does catches on the sides of the cabinet.
Loosen or tighten the adjustable feet to make the appliance level.

Water drain connection

Connect the water drain hose to:
• The sink spigot and attach it under the work surface. This prevents that the waste wa-
ter from the sink goes back into the appliance.
• A stand pipe with vent-hole. The internal di-
ameter must be minimum 4 cm.
Remove the sink plug when the appliance
drains the water to prevent that the water
goes back into the appliance.
The drain hose extension must not be longer
than 2 m. The internal diameter must not be
smaller than the diameter of the hose.
max 85 cm
min 40 cm