Installation; Before The Installation - ZANKER ZKF680 Benutzerinformation

Labels supplied with the accessories bag
Stick the adhesive labels as indicated below:
A
MOD.
PROD.NO.
SER.NO
DATA
A) Stick it on Guarantee Card and send this part (if
applicable).
B) Stick it on Guarantee Card and keep this part (if
applicable).

Installation

Warning! Refer to Safety chapters.

Before the installation

Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
Gas Connection
Warning! The following instructions
about installation, connection and
maintenance must be carried out by
qualified personnel in compliance with
standards and local regulations in force.
It is necessary that the connection to the gas mains are
carried out by means of an AGB tap. Choose fixed
connections or use a flexible pipe in AGB (stainless
steel) in compliance with the regulation in force (NBN D
22
B
MOD.
PROD.NO.
SER.NO
03 IT
DATA
MADE IN ITALY
C
MOD.
PROD.NO.
SER.NO.
0049
C) Stick it on instruction booklet.
51.003). If you use flexible metallic pipes, be careful
they do not come in touch with mobile parts or they are
not squeezed. Also be careful when the hob is put
together with an oven.
Make sure that the gas supply pressure
of the appliance obeys the
recommended values. The adjustable
connection is fixed to the comprehensive
ramp by means of a threaded nut G 1/2".
All the components shown in the figure
have already been assembled in the
factory. The appliance, before leaving
the factory, has been tested in order to
give you the best results.
TYPE
IP20