Installation; Connection Cable - ZANKER KEV6340FBB Benutzerinformation

Problem
comes on.
comes on.
and a number come on.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.

Installation

Warning! Refer to Safety chapters.
Before the installation
Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble the hob
into correct built-in units and work surfaces that align to
the standards.
20
All manuals and user guides at all-guides.com
Possible cause
Automatic Switch Off operates.
The Child Safety Device function
operates.
There is an error in the hob.
Deactivate the hob and activate it
again.
Refer to "Daily use" chapter.
Disconnect the hob from the electri-
cal supply for some time. Discon-
nect the fuse from the electrical sys-
tem of the house. Connect it again.
If
Authorised Service Centre.
Make sure, you operated the hob correctly. If not the
servicing by a service technician or dealer will not be
free of charge, also during the warranty period. The
instructions about the Service Centre and conditions of
guarantee are in the guarantee booklet.

Connection cable

• The hob is supplied with a connection cable.
• To replace the damaged mains cable use the
following (or higher) mains cable type: H05V2V2-F T
min 90°C. Speak to your local Service Centre.
Remedy
comes on again, speak to an