Periodic Maintenance; Troubleshooting - ZANKER ZKF680 Benutzerinformation

• To clean the enamelled parts, cap and crown, wash
them with warm soapy water and dry them carefully
before you put them back.
Cleaning the spark plug
This feature is obtained through a ceramic ignition
candle with a metal electrode. Keep these components

Troubleshooting

Warning! Refer to Safety chapters.
What to do if...
Problem
There is no spark when you try to
activate the spark generator.
The flame extinguishes immediately
after ignition.
The flame ring is uneven.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Make sure, you
operated the hob correctly. If not the servicing by a
well clean to prevent difficult lighting and check that the
burner crown holes are not obstructed.

Periodic maintenance

Speak to your local Authorised Service Centre
periodically to check the conditions of the gas supply
pipe and the pressure adjuster, if fitted.
Possible cause
The hob is not connected to an
electrical supply or it is connected
incorrectly.
The fuse is released.
Burner cap and crown are placed in-
correctly.
Thermocouple is not heated up suf-
ficiently.
Burner crown is blocked with food
residues.
service technician or dealer will not be free of charge,
also during the warranty period. The instructions about
the Service Centre and conditions of guarantee are in
the guarantee booklet.
Remedy
Check if the hob is correctly connec-
ted to the electrical supply.
Make sure that the fuse is the cause
of the malfunction. If the fuse relea-
ses again and again, contact a
qualified electrician.
Place the burner cap and crown cor-
rectly.
After lightning the flame, keep the
knob pushed for equal or less than
10 seconds.
Make sure that the injector is not
blocked and the burner crown is
clean.
21