Installation; Connection Cable; Before The Installation - ZANKER KEV6446XXK Benutzerinformation

Problem
and a number come on.
E6 comes on.
If you cannot find a solution...
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
Give the data from the rating plate. Give also three digit
letter code for the glass ceramic (it is in the corner of the
glass surface) and an error message that comes on.

Installation

Warning! Refer to Safety chapters.

Before the installation

Before you install the hob, write down the information
bellow from the rating plate. The rating plate is on the
bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble the hob
into correct built-in units and work surfaces that align to
the standards.
24
Possible cause
There is an error in the hob.
The second phase of the power
supply is missing.
Make sure, you operated the hob correctly. If not the
servicing by a service technician or dealer will not be
free of charge, also during the warranty period. The
instructions about the Service Centre and conditions of
guarantee are in the guarantee booklet.

Connection cable

• The hob is supplied with a connection cable.
• To replace the damaged mains cable, use the cable
type: H05V2V2-F which withstands a temperature of
90°C or higher. Speak to your local Service Centre.
Remedy
Disconnect the hob from the electri-
cal supply for some time. Discon-
nect the fuse from the electrical sys-
tem of the house. Connect it again.
If comes on again, speak to an
Authorised Service Centre.
Check if the hob is correctly connec-
ted to the electrical supply. Remove
the fuse, wait one minute, and insert
the fuse again.