Connection Of The Unit; Operation; Specifications - Monacor TVS-80 Bedienungsanleitung

4 Connection of the Unit

The camera switcher must always be separated from
the mains when connections to other units are made or
changed.
1) Connect the cameras to the BNC input jacks (9). Up
to eight cameras (resp. up to four cameras with
model TVS-40) can be connected. The numbers of
the input jacks are coordinated to the numbers of
the toggle switches (1), i. e. toggle switch 1 for the
input 1, etc.
2) Connect the monitor/s to the BNC output jacks (8).
3) Connect the mains plug to the mains socket
(230 V~/50 Hz).

5 Operation

Switch on the camera switcher with the POWER
switch (4). The red Power LED (3) is lighting with oper -
ation.
5.1 Automatic switching mode
In the automatic switching mode the pictures of the
camera inputs (9) are displayed on the monitor in ad -
jus t able switching intervals one after the other. The
camera inputs are passed through in the sequence
1–8 (resp. 1–4 with model TVS-40). The control lamp
above the corresponding toggle switch (1) lights up to
indicate the camera channel selected at present.
1) Set the toggle switches of the camera channels to
be shown in the automatic switching mode to posi-
tion AUTO. Set the toggle switches of the camera
channels which are not connected resp. to be
skipp ed to position BYPASS.
2) With the control RUN TIME (2) set the desired
switch ing interval between 1–15 seconds.
5.2 Manual selection and switching
of the camera
1) If a camera picture is to be displayed on the monitor
continuously, set the corresponding toggle switch
(1) of the camera input to position HOME. The con-
trol lamp above the toggle switch lights and thus
signalizes the selection of the camera channel.
2) For switching over to another camera channel, set
the toggle switch from position HOME back to its
previous position (AUTO or BYPASS) again and
the respective toggle switch of the desired camera
input to position HOME.
All rights reserved by MONACOR
be reproduced in any form or by any means for any commercial use.
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual may
®

6 Specifications

4 resp. 8 inputs: . . . . . . . . 1 Vpp / 75 Ω, BNC
2 outputs: . . . . . . . . . . . . . 1 Vpp / 75 Ω, BNC
Bandwidth: . . . . . . . . . . . . 20 MHz, ±3 dB
Channel separation: . . . . . > 48 dB
Permissible
operating temperature: . . . 0–40 °C
Power supply: . . . . . . . . . . 230 V~ / 50 Hz / 3 VA
Dimensions (W × H × D): . 220 × 44 × 120 mm
Weight: . . . . . . . . . . . . . . . 900 g
Subject to technical change.
GB
7