Conformity And Safety Declarations - Sunways NT 10000 Benutzerhandbuch

4.4

Conformity and Safety Declarations

Declaration of Conformity to EU Low Voltage Directive 73/23/EEC, Appendix III B
We hereby declare that the product described below, including the required accessories,
conforms to the provisions of EU Directive 73/23/EEC following 93/68/EEC:
Product
Manufacturer
Type
As from manufacturing date
Applied standards
Comments
This product is a component, which is designated for the installation in a PV system and therefore only can correspond to the
guidelines for end devices, machines or systems depending on where it is installed in the overall PV system. The assessment of
the electrical and mechanical safety and the environmental influences (foreign bodies, moisture) must follow in the installed
condition in the overall PV system. In the installed condition, the EMC characteristics of this product can change. Therefore for
the overall PV system, a check of the EMC characteristics through the final product manufacturer is practical. Changes reserved.
The currently valid issue is available upon request.
Solar Inverter
Sunways AG, Photovoltaic Technology
Macairestr. 3 - 5, D - 78467 Konstanz, Germany
Sunways NT 10000
15 September 2005
Standard EN 50178, EN 60950
Title Electronic equipment for use in power
installations
Edition 1998
Constance, 13 Sept. 2005
Place, date
160
Roland Burkhardt, Executive Board