Tyco Solarlok Connectors - Sunways NT 10000 Benutzerhandbuch

4.1

Tyco Solarlok Connectors

!
· Tyco Solarlok connectors may only be
connected to permanent lines!
· They may not be disconnected under
load!
· For this purpose, interrupt the electric
circuit at a suitable point! Put a corre-
sponding sticker on the lines near the
Tyco Solarlok connector!
· To avoid an electric shock, always
disconnect the Tyco Solarlok connec-
tors from all other voltage sources
during preparation!
Illustr.: Manual crimping tool for assembly
of Tyco Solarlok connectors
Contamination of any kind (dust, moisture,
etc.) has a negative effect on the working
order of the connector system over its aspi-
red service life. That especially applies to
the working order of the seals and the
crimping of the contacts. Therefore, make
sure everything is clean during assembly.
Illustr.: Tyco Solarlok connectors
154