Küppersbusch IKE458-5-4T Benutzerinformation Seite 33

• If using a plinth higher than 100 mm but
less than 140 mm, cut the height compen-
sation strip supplied with the appliance to
the required depth and fit it between the
plinth and the ventilation grille, pressing it
into position below this grille.
• If using a 100 mm plinth, fit the complete
height compensation strip.
Alignment height of 870 mm
• If using a 190 to 220 mm plinth, make a
shown.
• If using a plinth higher than 150 mm but
less than 190 mm, cut the height compen-
sation strip supplied with the appliance to
the required depth and fit it between the
plinth and the ventilation grille.
• If using a 150 mm plinth, fit the complete
height compensation strip.
• If the appliance is installed at the end of a
row of units, insert foot E to hold the
plinth in place.
33