Küppersbusch IKE458-5-4T Benutzerinformation Seite 32

32
• Fix the bracket located under the door to
the panel with the two plastic washers
contained in the box of accessories.
• Then refit the bracket cover.
Building the appliance in
• Fit the appliance into the recess.
• Rotate the bracket of 180° in order to ob-
tain the right position ( 2). The position (1)
is on the delivery.
• Fix it to the wall with the appropriate brack-
et.
• The top of the appliance must be kept
clear to allow better air circulation. If a
wall unit is fitted above the appliance,
there must be a gap of 50 mm between
this unit and the wall and it must be at
least 50 mm below the ceiling.
Fitting the plinth
Alignment height of 820 mm
• If using a 140 to 170 mm plinth, make a
cut-out as shown.