Nibe UKV 200 Montageanleitung Seite 7

INSTALLATION INSTRUCTIONS
GB
UKV 200-300 / COOLING
General
UKV consists of a condensation insulated steel vessel
with Freon-free polyurethane insulation. The outer cas-
ing is made of durable plastic.
UKV has many areas of use:
- Cooling:
For systems with cooling, a buffer tank is required if, for
example, one has a supply air coil operating with a heat
pump and active/passive cooling.
- Volume expansion:
In the context of heat pumps, 20 l/kW is required and
many heating systems do not have such a volume. To
prevent operational problems, the volume is then ex-
panded using a UKV.
- Flow increaser:
If the heating flow can be throttled uncontrolled, a UKV
is installed as an intermediate tank. This ensures a se-
cure flow for the heat pump and ensures a high flow to
the heating system.
- Eliminating heat spikes:
In some installations, so-called heat spikes occur as a
result of movements during temperature changes. To
eliminate temporary temperature changes, install a UKV
after the heating installation.
Installation
UKV is easy to install as it is a floor model with adjust-
able feet and easy to access pipe connections.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Rights to make any design or technical modifications are reserved.
©NIBE 2012.
UKV 200-300 / COOLING 7