Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Replacing The Oven Light Bulb - Siemens HQ738155E Gebrauchs- Und Montageanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Fold up the left and right locking levers. Make sure that, when
2.
the locking levers are folded up, you do not close the oven
door. The hinges may become bent which may cause
damage to the enamel.

Open the oven door at an angle. Hold it on the right and left
3.
with both hands. Close it just a little further and pull it out.

Troubleshooting

Malfunctions often have simple explanations. Refer to the table
before calling the after-sales service, as you may be able to
remedy the fault yourself.
Problem
The appliance does not work.
The oven lighting has failed.
The gas burner does not ignite.
The flame (oven) does not burn
through all outlet openings.
All dishes prepared in the oven may
burn within a short period of time.
The door panel steams up when the
oven is hot.

Replacing the oven light bulb

If the bulb in the oven light fails, it must be replaced.
Replacement heat-resistant bulbs can be obtained from the
after-sales service or from specialist retailers. Please supply
your appliance's E number and FD number. Do not use any
other type of bulb.
Switch off the appliance at the circuit breaker or pull out the
1.
mains plug.
2.
Open the appliance door.

Possible cause
Defective circuit breaker
Power cut
Oven light is faulty
Power cut or damp ignition plugs
Normal build-up of dirt
Defective thermostat
Normal occurrence; caused by the differ-
ence in temperature.
Fitting the appliance door
When hooking in the oven door, ensure that the notch on the
1.
bottom of the hinge locks into the slot.
Fold down both locking levers on the left and right again and
2.
close the oven door.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call the after­sales
service.
:
Risk of injury!
Incorrect repairs may cause serious hazards. Repairs to the
appliance may only be performed by a qualified person. If
repairs are required, contact the after-sales service.
Malfunction table
Remedy/information
Look in the fuse box and check that the circuit
breaker is OK.
Check whether the kitchen light is working.
Change the oven light bulb. (see section
"Replacing oven light")
Light the gas burner with a gas lighter or a
match.
The burner must be professionally cleaned.
Call the after­sales service.
Not possible; this has no effect on oven per-
formance.
3.
Lay a tea towel in the cold cooking compartment to prevent
damage.
Unscrew the glass cover from the defective oven light bulb
4.
inside the cooking compartment by turning it anti-clockwise.
29

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis