Rating Plate; Guidelines For Ventilation; Installation; Fitting The Adjustable Feet - Siemens HQ738155E Gebrauchs- Und Montageanleitung

Rating plate

The technical data for the appliance can be found on the rating
plate.
The rating plate is located on the inside of the storage
compartment flap.
The setting values are specified on a label on the appliance
packaging.
Enter the product number (E no.), production number (FD no.),
factory settings for the type of gas/gas pressure and, if
applicable, the converted gas type into the table below. The

Guidelines for ventilation

This appliance may only be set up in a sufficiently ventilated
room and according to the applicable regulations and
ventilation requirements.
Please note that the air volume required for combustion must
not be below 2 m³ per kW of power (see kW total power on the
rating plate).

Installation

This appliance is always supplied with a set of adjustable feet
and, depending on the model, with a splash guard. The
appliance may also be used without the splash guard.

Fitting the adjustable feet

1. Remove all parts that are not permanently fixed, especially
the pan supports and burners.
2. Remove the accessories from the oven.
Tilt the appliance by lifting one side from the floor.
3.
Screw the adjustable feet into the mounting holes on the
4.
underside of the appliance. If you then have to pull the
appliance, fully screw in the adjustable feet.
Only finally level the appliance when the electricity and gas
5.
have been connected and all of the installation work has
been completed.
32
changes made to the appliance and the type of connection are
crucial for the safe and correct operation of the appliance.
E no.
O
After-sales service
Type of gas/gas pressure
Factory setting
Type of gas/gas pressure
Conversion
For appliances with a total power of up to 11 kW, it is sufficient
if the room where it is to be installed has a capacity of more
than 20 m³ and at least one door to the outside or a window
that can be opened.
Note: In some countries, there are differing requirements
concerning the minimum capacity. Your after-sales service
department will provide you with information about this.

Fitting the splash guard

1. Remove the packaging and the protective film from the
splash guard.
2. Loosen the 4 screws on the back of the appliance.
3. Place the splash guard onto the screws using the slots in the
splash guard provided for this purpose.
4. From above, place the 2 screws provided into the holes for
this in the splash guard.
Tighten all screws firmly.
5.
FD no.