Maintenance And Disposal; Mise En Service - Conrad 61 03 68 Bedienungsanleitung

Dans les locaux professionnels, il faut observer les instructions pour
la prévention des accidents émises par les associations profession-
nelles exerçant dans le domaine des installations électriques et de
l'outillage industriel.
Au cas où vous ne seriez pas complètement sûr de la manière
dont il faut brancher correctement cet appareil ou si vous aviez
des questions auxquelles le mode d'emploi n'a pu répondre,
prenez contact avec notre service technique ou demandez
l'avis d'un autre spécialiste.

Mise en service

Afin d'assurer une mise en service correcte, lisez,
avant l'utilisation, attentivement et complètement
tout ce mode d'emploi avec toutes les consignes de
sécurité.
26
If the image should prove to be unsharp you may adjust its sharp-
ness. Open the lens cover (1) (by rotating it), loosen the hexagon
socket screw (4), and turn the lens (3). Proceed in an inverse order
to close the cover.
Note: Do not fail to firmly re-close the lens cover to prevent
moisture from entering.
Never operate the camera with no cover because
this could cause moisture to enter.

Maintenance and disposal

Maintenance
Check the camera and the power source connected to it for their
technical safety at regular intervals, e.g. for damage to the connect-
ing cables and the housings.
If there is room to believe that safe operation has become impossi-
ble put the camera and the power supply unit out of operation and
secure it against any unintended operation. Withdraw the mains
plug from the socket.
Safe operation must be presumed to be no longer possible, if:
• the camera or connecting lines for power supply units exhibits
visible damage
• the camera or power supply units connected to it do not operate
any longer
• the camera was stored under unfavourable conditions for a long
period of time.
• the camera was exposed to extraordinary stress caused by trans-
port.
19