Deleting All Programming/Cards - Assa Abloy ANYKEY Bedienungsanleitung

Sicherheitsbeschlag mit integrierter Zutrittskontrolle

2.10 Deleting all programming/cards

Whenever you delete all of the data in a fitting, it is reset to installation mode.
Caution
An access by unauthorised persons is possible! There is a security leak here.
You should program the Master Card immediately.
If you want to leave the fitting in the original installation state, this can be activated with any card.
If you cancel all programming entries, then:
All User Cards will be deleted.
The Clear Card will be deleted.
The Master Card will be deleted.
The security fitting will be activated.
The fitting can be switched back and forth between activated and deactivated with any card.
Deleting all information from the memory of the security fitting
Notice
If you see a different sequence of flashing lights, then the deletion has failed. All programmed cards
continue to be valid. Read through the described sequence once more and then carry out the deletion
procedure once more.
All Cards have been deleted.
The security fitting is now activated.
Seite 44
Start the programming.
Whilst the indicators are flashing, hold the card in front of the card
reader again.
Whilst the indicators are flashing, hold the card in front of the card
reader again.
Whilst the indicators are flashing, hold the card in front of the card
reader again.
Deletion command for all Cards has been recognised. Deletion process
completed.
D00422
02