What To Do If - AEG Electrolux FAVORIT EXPRESS VI Benutzerinformation

22

What to do if...

WHAT TO DO IF...
The appliance does not start or stops during operation.
First try to find a solution to the problem (refer to the chart). If not, contact the service
centre.
Malfunction
The appliance does not
fill with water.
The appliance does not
drain the water.
The anti-flood device
operates.
The programme does
not start.
Fault code
The display shows
The display shows
The display shows
Possible cause
The water tap is
blocked or is furred
with limescale.
The water pressure is
too low.
The water tap is
closed.
The filter in the water
inlet hose is blocked.
The connection of the
water inlet hose is not
correct.
The water inlet hose is
damaged.
There is a blockage in
the sink spigot.
The connection of the
water drain hose is not
correct.
The water drain hose is
damaged.
The appliance door is
open.
The mains plug is not
connected in.
Blow out fuse in the
household fuse box.
The delay start is set.
Possible solution
Clean the water tap.
Contact your local wa-
ter authority.
Open the water tap.
Clean the filter.
Make sure that the
connection is correct.
Make sure that the
water inlet hose has
no damages.
Clean the sink spigot.
Make sure that the
connection is correct.
Make sure that the
water drain hose has
no damages.
Close the water tap
and contact the serv-
ice centre.
Close the door correct-
ly.
Put in the mains plug.
Replace the fuse.
If you want to cancel
the delay start, refer to
'Setting and starting a
washing programme'.