Replacing The Lamp - Electrolux ERES38810W Benutzerinformation

Problem
Not enough carbon diox-
ide in the water.
Too much carbon dioxide
in the water.
No carbon dioxide.
No or very low water flow. The gas cylinder is empty.
Only gas comes out when
dispensing carbonated
water.
The water filter indicator
flashes.
The water filter indicator
lights constantly.
The water dispenser lamp
and the child lock indica-
tor flashes.
Dispensing is interrupted
after a short time.
The lamp does not work.
Door interferes with ven-
tilation grill.
Misaligned door.
As much as the advice does not lead to result, call the nearest brand-mark service.

Replacing the lamp

1. Disconnect the appliance from the power
socket.
2. Disassemble the lamp by using a screw-
driver in the recess on the lamp insert.
3. Assemble a new lamp by guiding it into a
centred position and press until it snaps.
Use a halogen bulb of the same type,
maximum rating of 20 W
Possible cause
The appliance has no power.
There is no voltage in the mains
socket.
The carbon dioxide is running
out.
Dilute with ordinary water.
The gas cylinder is empty.
Sediment in the water.
Water supply obstructed.
Water supply obstructed.
Sediment in the water.
The filter has been totally con-
sumed.
20% of filter capacity remains.
Internal leakage at the water con-
nection.
Leakage from filter operation.
The maximum time of two mi-
nutes is exceeded.
The door has been open to long. Close the door.
The lamp is defective.
The appliance is not levelled.
The appliance is not levelled.
Connect a another electrical appli-
ance to the mains socket. Check
fuse. Contact a qualified electri-
cian.
Refer to "Installation of the gas cyl-
inder".
Refer to "Selecting and dispensing
water".
Refer to "Replacing gas cylinder"
Refer to "Replacing gas cylinder".
Remove and clean the strainer in
the inlet hose connection.
Check water supply.
Check water supply.
Remove and clean the strainer in
the inlet hose connection.
Refer to "Replacing the water fil-
ter".
Buy a new filter.
Contact your local Electrolux Serv-
ice Force Centre.
Open water module hatch and dry
up water from the bottom, look for
leakages.
If filter leaks, refer to "Replacing the
water filter"
Start new dispensing.
Refer to "Replacing the lamp".
Refer to "Levelling".
Refer to "Levelling".
4. Reconnect the appliance.
electrolux 13
Solution