Electrolux ERES38810W Benutzerinformation Seite 15

mm . Ideally, however, the appliance should
not be positioned below overhanging wall
units.
If the cabinet is placed in a corner and the
side with the hinges facing the wall, the dis-
tance between the wall and the cabinet must
be at least 150 mm to allow the door to open
enough so that the equipment can be re-
moved.
The ventilation space can be:
• directly above the appliance
• behind and above the top cupboard.
In this case, the space behind the top cup-
board must be at least 50 mm deep.
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
The manufacturer declines all responsibility if
the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Di-
rectives.
Removing the transport support
Your appliance is equipped with transport
support to secure the door and the pump
during transportation.
To remove them do these steps:
1. Open the door.
2. Remove the transport support from the
door sides.
3. Remove the transport support from the
lower hinge (some models).
4. Remove the transport support from un-
derneath the water unit.
5. Cut the pump securing tie and remove it.
Important! Some models are fitted with a
silencing pad under the cabinet. Do not
remove this pad.
50mm
Removing the shelf holders
Your appliance is equipped with shelf retain-
ers that make it possible to secure the
shelves during transportation.
To remove them proceed as follows:
3
5
electrolux 15
2
4