Electrolux ERES38810W Benutzerinformation Seite 12

12 electrolux
Problem
Sound level is too high
during dispensing of wa-
ter.
The buzzer sounds. The
Alarm light flashing.
upper or lower square
is shown in the tempera-
ture display.
The compressor runs
continuously.
Water flows inside the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low.
The temperature in the
appliance is too high.
The temperature in the re-
frigeration is too high.
The appliance does not
operate.
Possible cause
The spacers located between the
back of the cabinet and the pipes
come loose.
The transport supporting tie of
the water system pressure pump
has not been removed.
The door is not closed correctly.
An error has occurred in measur-
ing the temperature
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The door has been opened too
frequently.
The food temperature is too high. Let the food temperature decrease
The room temperature is too
high.
The water outlet is clogged.
Food prevent that water flows in-
to the water collector.
The melting water outlet does not
flow in the evaporative tray above
the compressor.
The Temperature regulator may
be set incorrectly.
The Temperature regulator may
be set incorrectly.
The door is not closed correctly.
The food temperature is too high. Let the food temperature decrease
There is no cold air circulation in
the appliance.
Large quantities of food to be
cooled were put in at the same
time.
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
Solution
Put them back in place again.
Remove the tie. Refer to "Remov-
ing the transport support".
Refer to "Door open alarm".
Call your service representative
(the cooling system will continue to
keep food products cold, but tem-
perature adjustment will not be
possible)
Set a warmer temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
to room temperature before stor-
age.
Decrease the room temperature.
Clean the water outlet.
Make sure that food do not touch
the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the door".
to room temperature before stor-
age.
Make sure that there is cold air cir-
culation in the appliance.
Insert smaller quantities of food to
be cooled at the same time.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.