First Use - Electrolux ERES38810W Benutzerinformation

To activate the child lock function
Press buttons 2 and 3 at the same time for
about three seconds.
Activation is indicated by the child lock indi-
cator is lighting.
Selecting and dispensing water
Before dispensing water, select either car-
bonated water (2) or plain water (3). The ac-
tual choice is indicated by the lit button.
Water selection can be changed while the
water is running.
Water is dispensed by pressing a glass or
other container towards the flap (6). Draw
back the glass or container to stop the water
flow.
Any water that drips or is spilled is collected
in the drip tray below the water dispenser.
The drip tray can be detached and emptied
when necessary.
Lighting
The water dispenser lighting (7) illuminates
automatically when water is dispensed.
For continuous lighting
1. Make sure that the water dispenser is un-
locked.

First use

Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessories
with lukewarm water and some neutral soap
so as to remove the typical smell of a brand-
new product, then dry thoroughly.
Important! Do not use detergents or abra-
sive powders, as these will damage the fin-
ish.
Check that the drain hose at the rear of the
cabinet discharges into the drip tray.
2. Press the plain water button (3) until the
lighting goes on (about three seconds).
Brightness is now about 50% until the dis-
penser is used.
Switch off the lighting
1. Make sure that the water dispenser is un-
locked.
2. Press the plain water button (3) until the
lighting goes out (about three seconds).
Water filter indicator
When the water filter indicator (4) lights up the
water filter has about 20% remaining lifetime.
In this situation, it is recommended that you
buy a replacement filter.
When the water filter indicator starts flashing,
the water filter lifetime is consumed .
Replace the water filter without delay, refer to
"Installation of the water filter".
When the water filter is replaced. Press the
plain water button (3) for a few seconds to
reset the water filter indicator.
electrolux 7