What To Do If - Renlig FWMND6 Handbuch

ENGLISH
• place a bowl on the floor and place the
end of the emergency emptying hose into
the bowl. Remove its cap. The water
should drain by gravity into the bowl.
When the bowl is full, put the cap back on
the hose. Empty the bowl. Repeat the pro-
cedure until water stops flowing out;

What to do if...

The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
•
- The appliance does not fill with wa-
ter.
Warning! Switch off the appliance before you do the checks.
Problem Possible cause
The water tap is closed.
The inlet hose is squashed or
kinked.
The filter in the inlet hose or the inlet
valve filter are blocked.
The appliance
does not fill: The water tap is blocked or is furred
with limescale.
The connection of the water inlet
hose is not correct.
The water pressure is too low.
The door is not properly closed.
The drain hose is squashed or
kinked.
The appliance
The drain filter is clogged.
does not drain
the water:
The connection of the drain hose is
not correct.
• clean the pump if necessary as previously
described;
• replace the emergency emptying hose in
its seat after having plugged it;
• screw the pump cover again and close the
door.
•
- The appliance does not drain the
water.
•
- The appliance door is open or not
closed correctly.
Solution
Open the water tap.
Check the inlet hose connection.
Clean the water inlet filters. (See
"Cleaning the water inlet filters" for
more details).
Clean the water tap.
Check the inlet hose connection.
Contact your local water authority.
Close the door firmly.
Check the drain hose connection.
Clean the drain filter.
Check the drain hose connection.
21