Renlig FWMND6 Handbuch Seite 23

ENGLISH
Problem Possible cause
The emergency cap for emptying
has not been replaced into the filter
or the filter has not been properly
screwed in after cleaning action.
The washing programme is still run-
ning.
The door will The door lock has not been re-
not open: leased.
There is water in the drum.
The transit bolts and packing have
not been removed.
The appliance
The support feet have not been ad-
produces an un-
justed
usual noise
The drain pump could be blocked.
Too little detergent or unsuitable
detergent has been used.
Stubborn stains have not been trea-
ted prior to washing.
Unsatisfactory
The correct temperature was not
washing results:
selected.
Excessive laundry load.
After the check, switch on the appliance and
press the button 5 to restart the programme.
If the malfunction shows again, contact your
After Sales Service.
Solution
Refit the emergency cap for empty-
ing or screw the filter fully in.
Wait the end of washing pro-
gramme.
Wait a few minutes until the door
indicator light goes off.
Select drain or spin programme to
empty out the water.
Check the correct installation of the
appliance.
Check the correct levelling of the
appliance.
Check the drain pump. (See "Clean-
ing the pump" for more details).
Increase the detergent quantity or
use another one.
Use commercial products to treat
the stubborn stains.
Check if you have selected the cor-
rect temperature.
Reduce the laundry load in accord-
ing to the "Washing Programmes
table".
The necessary data for the service centre is
on the rating plate. We recommend that you
write the data here:
23