Herunterladen Inhalt Inhalt Diese Seite drucken

Renlig FWMND6 Handbuch Seite 13

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

ENGLISH
• The selected delay can be changed
only after selecting the washing pro-
gramme again.
• The door will be locked throughout
the delay time. If you need to open
the door, you must first set the wash-
ing machine to PAUSE by pressing
button 5 and wait a few minutes be-
fore opening the door. After you have
closed the door, press the same but-
ton again.
• The Delay Start cannot be selected
with the draining programme.
Start the programme by pressing button 5
To start the selected programme, press this
button; the corresponding green indicator
light stops blinking.
The indicator light 3 illuminates to indicate
that the appliance starts operating and the
door is locked.
If you have chosen a delayed start, the ma-
chine will begin the countdown.
If an incorrect option is selected, the
message Err appears on the display for
a few seconds and the red indicator light of
the button 5 blinks 3 times.
Altering an option or a running programme
It is possible to change some options before
the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the button
5.
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to O and then to the new pro-
gramme position. Start the new programme
by pressing the button 5 again. The washing
water in the tub will be not emptied out.
Interrupting a programme
Press the button 5 to interrupt a programme
which is running, the corresponding green in-
dicator light starts blinking.
Press the button again to restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to O to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
button 5.
If the indicator light 3 blinks and after a few
minutes goes off, the door can be opened.
If the indicator light 3 remains lit, this means
that the machine is already heating or that
the water level is too high. In any case, do
not try to force the door open!
If you cannot open the door but you need to
open it, you have to switch the machine off
by turning the selector dial to
minutes the door can be opened.
After closing the door, it is necessary to select
the programme and options again and to
press button 5.
Caution! Pay attention to the water
level and temperature!
At the end of the programme
The machine stops automatically. Some
acoustic signals sound and a blinking
pears on the display, the indicator light of
button 5 and the indicator light 3 go off.
If a programme or an option that ends with
water left in the tub has been selected, the
indicator light 3 remains on and the door is
locked to indicate that the water must be
emptied out before opening the door.
To empty out the water:
1. Turn the programme selector dial to
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing button 10.
4. Press button 5.
At the end of the programme, the door is re-
leased and can be opened. Turn the pro-
gramme selector dial to
chine off.
13
. After a few
ap-
.
to switch the ma-

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis