What To Do If - Renlig FWM6 Handbuch

ENGLISH
3
35° 45°

What to do if...

The appliance does not start or stops during
operation. It is possible that the red indica-
tor light of button 4 blinks to indicate that
the appliance is not working.
Problem Possible cause
The door has not been closed (The
red indicator light of button 4
The appliance
blinks).
does not start:
The plug is not properly inserted in
the power socket.
• Screw the hose
back to the appli-
ance turning it to
the left or the
right to suit the
installation. Tight
the locknut cor-
rectly to prevent
water leaks.
• Turn on the water
tap.
The dangers of freezing
If the appliance is installed in a place where
the temperature could drop below 0°C,
proceed as follows to remove any water re-
maining inside the appliance:
1. unplug the appliance;
2. turn off the water tap;
3. unscrew the water inlet hose from the
tap;
4. unfasten the drain hose from the rear
support and unhook it from sink or spi-
got;
1
5. place a bowl on the floor;
6. let the drain hose run along the floor,
place the external extremities of the
drain and inlet hoses in the bowl
placed on the floor and let water drain
out completely;
7. screw the water inlet hose back on and
reposition the drain hose again;
When you intend to start the appliance up
again, make sure that the room tempera-
ture is above 0°C.
Before contacting your local Service Centre,
please carry out the checks listed below.
Solution
Close the door firmly.
Insert the plug into the power
socket.
21
2