Renlig FWMND6 Handbuch Seite 22

ENGLISH
Problem Possible cause
An option or a programme that
ends with the water still in the tub or
a that eliminates all the spinning
phases has been selected.
The appliance
door is open or
not closed cor-
rectly.
The plug is not properly inserted in
the power socket.
There is no power at the socket.
The main fuse has blown.
The appliance
The programme selector dial is not
does not start:
correctly positioned and the button
5 has not been pressed.
The delay start has been selected.
The Child Lock function is activated.
The electronic unbalance detection
device has cut in because the laun-
dry is not evenly distributed in the
drum. The laundry is redistributed
The appliance
by reverse rotation of the drum. This
spinning phase
may happen several times before
starts late or
the unbalance disappears and nor-
does not start:
mal spinning can resume. If, after 10
minutes, the laundry is still not even-
ly distributed in the drum, the appli-
ance will not spin.
Too much detergent or unsuitable
detergent (creates too much foam)
has been used.
Check whether there are any leaks
from one of the inlet hose fittings. It
There is water
is not always easy to see this as the
on the floor:
water runs down the hose; check to
see if it is damp.
The drain or inlet hose is damaged.
Solution
Select the draining or spinning pro-
gramme.
Close the door firmly.
Insert the plug into the power sock-
et.
Please check your domestic electri-
cal installation.
Replace the fuse.
Please turn the selector dial and
press the button 5 again.
If the laundry are to be washed im-
mediately, cancel the delay start.
Deactivate the Child Lock function.
Redistribute the load manually or
load more laundry and select the
spin programme.
Reduce the detergent quantity or
use another one.
Check the water inlet hose connec-
tion.
Replace it with a new one (check
with the After Sales Service the right
spare part number).
22