Memorising A Station; To Recall A Memorised Station; To Scan The Preset Stations; To Erase Entire Preset Memory - Sharp CD-XP300H Bedienungsanleitung

Listening to the radio (continued)
CD-XP300H
ENGLISH

„ Memorising a station

You can store 40 AM and FM stations in memory and recall them at the push of a but-
ton. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning" on page 14.
2
Press the MEMORY/SET button to enter the preset tuning saving
mode.
3
Within 30 seconds, press the PRESET ( or ) button to select the
preset channel number.
Store the stations in memory, in order, starting with preset channel 1.
4
Within 30 seconds, press the MEMORY/SET button to store that
station in memory.
If the "MEMORY" and preset number indicators go out before the station is
memorised, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a preset sta-
tion.
When a new station is stored in memory, the station previously memorised will
be erased.
Note:
The backup function protects the memorised stations for a few hours should there be
a power failure or the AC power lead disconnection.
E-15
Tuning (See page 14.)

„ To recall a memorised station

Press the PRESET ( or ) button for less than 0.5 seconds to select
the desired station.
Preset channel
This operation can be performed by pressing the TUNER PRESET (
or or button on the remote control.

„ To scan the preset stations

The stations saved in memory can be scanned automatically. (Preset memory scan)
1 Press the PRESET ( or ) button for more than 0.5 seconds.
z The preset number will flash and the programmed stations will be tuned in se-
quentially, for 5 seconds each.
z This operation can be performed by pressing the TUNER PRESET (
button or or button on the remote control.
2 Press the PRESET ( or ) button again when the desired station is located.

„ To erase entire preset memory

1 Press the ON/STAND-BY button to enter the stand-by mode.
2 Whilst pressing down the TUNER (BAND) button and the EQUALIZER/X-BASS/
DEMO button, press the ON/STAND-BY button until "TUNER CL" appears.
01/12/11 CD-XP300H(H)E2.fm
Frequency and frequency band
or ) button
or )