Overheat Protection - everActive NC 3000 Bedienungsanleitung

500mA. For the 800mAh R03/AAA batteries the
recommended charging current is 200mA.
Full charge termination method -∆V is less accurate with
lower than recommended charging currents.

8. Overheat protection.

One of the most advanced and unique features of
everActive NC-3000 is the overheat protection system. The
charger was built using the latest, most advanced,
optimized, thermal efficient design. Overheat problem is
not likely to occur. But still, in general the temperature will
increase significantly when using highest charging currents
or bad quality cells. Therefore our charger is equipped with
six independent temperature sensors to protect both the
inserted batteries and the charger. If temperature of any
of the inserted cells rises over 60 degrees Celsius or the
charger's internal circuitry temperature rises over 77
degrees then the operation will be interrupted and "0mA"
icon will be shown on display. The process will resume
when the battery's temperature drops to 40 degrees
Celsius or the charger's internal circuitry temperature
drops below 50 degrees.
9. Operation modes and display readings.
Charge mode – inserted batteries will be charged
automatically with the (pre)selected charging current.
9