everActive NC 3000 Bedienungsanleitung Seite 11

capacity of older cells, which were not used for an
extended period of time. Can be used to initialize/form
new batteries and check their real capacity or to reduce
the memory effect. Please take note that this process can
take even few days to complete. At the end of the process
maximum cell capacity can be read from LCD display.
Please take a note – discharging current which is used to
determine the capacity is always ½ of the selected
charging current.
Stage 1. Several charge/discharge cycles with capacity test.
Pressing "Display" button will show various information – time,
discharging current, voltage level, momentary capacity in mAh/Ah.
Stage 2. End of refresh process. Trickle charge is applied to
maintain full charge of the inserted batteries.
Icon "Full" will be shown on display. Pressing "Display" button will show
various information – time, trickle charging current, voltage, maximum
measured capacity from the last cycle in mAh/Ah.
Test mode – can be used to test rated capacity of inserted
batteries. Please take note that new rechargeables may
need few charge/discharge cycles to reach their maximum
capacity. Batteries with much lower results than declared
should not be used. For the best results and performance
it is recommended to use the "everActive" rechargeables.
Please take a note – discharging current which is used to
determine the capacity is always ½ of the selected
11