Warnings, Cautions And Others; Precautions For Installation; Checking The Components; Assembling The Front And Surround Speakers - JVC SP-XF30 Bedienungsanleitung

Warnings, Cautions and Others

Precautions for installation

• Do not install the speakers on an uneven surface or in a place subject
to vibration; otherwise, they may fall over, causing damage or injury.
• The speakers are magnetically shielded to avoid color distortions on
TVs if they are installed properly.
– When placing the speakers near a TV set, turn off the TV's main
power switch or unplug it before installing the speakers.
Then wait at least 30 minutes before turning on the TV's main power
switch again. If there are still distortion, move the speakers further
away from the TV.
Precautions for daily use
• Do not reproduce sounds at so high a volume that they are distorted;
otherwise, the speakers may be damaged by internal heat buildup.
• When moving the speakers, do not pull the speaker cords; otherwise,
the speakers may fall over, causing damage or injury.
• When holding a speaker, always grasp the lower portion.

Checking the Components

Check to be sure you have the following components.
The number in parenthesis indicates the quantity of the piece supplied.
Surround Front
speakers (2)
speakers (2)
• Speaker cords— 4 m (3): For front/center speakers
• Speaker cords— 10 m (2): For surround speakers
• Screws— M5 x 25 mm (8)
Only for SP-XF70
Surround back speaker (1) and
Speaker cord— 10 m (1)
If any of the items above are missing, contact your dealer immediately.
Assembling the front and surround
speakers
Assembled speakers: With stand:
Without stand: Refer to Steps 1 to 5
or
With stand Without stand
SP-XF30S
Before assembling—
• Prepare a Philips screwdriver (not supplied).
• Take care not to drop any component part while assembling;
otherwise, it may cause damage to the floor or injury.
• Each speaker cord has its name tag attached to one end. Attach the
end without the name tag to the speaker terminal.
Center speaker (1)
Stands (4) Base plates (4)
Refer to Steps 1 to 6
or
With stand Without stand
SP-XF30F
– 4 –
1
2
Base plate
(Rear side)
3
Stand
(or speaker
directly)
Base plate
4
5
Press
Red
Black
Black striped
6
Speaker
Stand
Speaker cord
Route the cord
Speaker cord
Screw
(M5 x 25 mm)
Insert Release
Copper
Speaker cord
White
Black