Cleaning And Maintenance - Scheppach 5909252948 Originalbetriebsanleitung

Mode Yellow
light
Bicycle < 30
mode psi
Motorcycle < 2 bar
mode
Car mode < 2 bar
Ball mode < 4 psi
Manual
mode
10.3 Adjusting the pressure (Fig. 1)
ATTENTION! If the measured pressure
is higher than the maximum value that
is pre-set in the selected more, the light
illuminates red.
The pressure can also be regulated us-
ing the "+" (14) and "-" (13) buttons.
The "+" button can be used to increase
the pressure.
The "-" button can be used to decrease
the pressure.
10.4 Inflate (Fig. 1)
• Press the On/Off switch on the pump
(9) to start the inflation process.
40 | GB
Green Light
light blue
light
30-50
psi
2-3
bar
2-3
bar
6-16
psi
Con-
tinu-
ous
www.scheppach.com
• The pump stops automatically as soon
as the pre-set pressure is reached.
• It can also be stopped by pressing the
On/Off button on the pump (9) again.
• After inflating, first remove the adapter
(19, 20, 21) from the compressed air
hose and then pull the compressed air
hose (16) off the device.
10.5 LED work lamp (Fig. 1)
This product is equipped with an LED
work lamp (2) to illuminate the immediate
work area and improve visibility in poorly
lit environments.
CAUTION! Do not look directly into the
LED work lamp or the light source.
1 Press the LED button (12) again for a
short time to switch the LED work light
(2) on.
2 Pressing again causes the light to
flash in SOS mode.
3 Pressing a third time switches the light
off again (the LED work light can also be
used when the device is switched off).

11. Cleaning and maintenance

• Keep protective devices, air vents and
the engine housing as free of dust
and dirt as possible. Rub the product
clean with a clean cloth or blow it off
with compressed air at low pressure.