Troubleshooting - Scheppach Hc06 Originalbetriebsanleitung

the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to appliances that
are installed and sold in the countries of the Euro-
pean Union and are subject to European Directive
2012/19/EU. Different provisions may apply to the
disposal of electrical and electronic appliances in
countries outside the European Union.

13. Troubleshooting

Fault Possible cause
Mains voltage is not available.
Mains voltage is too low.
The compressor
does not start.
Outside temperature is too low.
Motor is overheated.
Non-return valve leaking
The compressor
starts but there is The seals are damaged.
no pressure.
Drain screw for condensate (9)
leaking.
The hose connections have a leak.
The compressor
starts, pressure is
shown on the pres- A quick coupling has a leak.
sure gauge, but the
Pressure set too low at pressure
tools do not start.
regulator (3).
Remedy
Check the cable, mains plug, fuse and socket.
Make sure that the extension cable is not too long.
Use an extension cable with large enough wires.
Never operate with an outside temperature of below
+5° C.
Allow the motor to cool down. If necessary, remedy
the cause of the overheating.
Replace the non-return valve.
Check the seals and have any damaged seals re-
placed by a service centre.
Tighten the screw by hand.
Check the seal on the screw and replace if necessary.
Check the compressed air hose and tools and replace
if necessary.
Check quick coupling, replace if necessary.
Increase the set pressure with the pressure regulator.
www.scheppach.com GB | 31