Technical Data - Scheppach Dp55 Original Bedienungsanleitung

debris can cause injuries.
i) The permissible rotational speed for drill bits
with a rated speed must be at least as high as
the highest speed cited on the electrical tool.
Accessories that rotate faster than permitted can
break and fly off at high speed.
Attention: Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and you environment from acci-
dents using suitable precautionary measures!
• Do not look directly into the laser beam with un-
protected eyes.
• Never look into the path of the beam.
• Never point the laser beam towards reflecting sur-
faces and persons or animals. Even a laser beam
with a low output can cause damage to the eyes.
• Caution - methods other than those specified here
can result in dangerous radiation exposure.
• Never open the laser module. Unexpected exposure
to the beam can occur.
• The laser may not be replaced with a different type
of laser.
• Repairs of the laser may only be carried out by the
laser manufacturer or an authorised representative.
• Labelling and placement of warning stickers, see
fig. 8 and 9.
m WARNING! This electric tool generates an electro-
magnetic field during operation. This field can impair
active or passive medical implants under certain con-
ditions. In order to prevent the risk of serious or deadly
injuries, we recommend that persons with medical im-
plants consult with their physician and the manufactur-
er of the medical implant prior to operating the electric
tool.
26 | GB
Residual risks
Even if you use this electric power tool in accord-
ance with instructions, certain residual risks can-
not be eliminated. The following hazards may
arise in connection with the equipment's con-
struction and layout:
• Lung damage if suitable dust protection mask is not
worn.
• Hearing damage if suitable hearing protection is not
worn.
• Damage to health resulting from hand/arm vibration
if the device is used over an extended period of time
or if it is not properly operated and maintained.

6. Technical data

AC motor
Nominal power S1
Operating mode
Idle speed n
Drill chuck clamping range
Max. drill stroke
Size of base plate
Distance of drill-chuck to
base plate
Weight approx.
Protection class
Laser class
Laser wavelength
Laser power
Subject to technical modifications!
* After an uninterrupted operating period of 5 minutes,
the device should be allowed to rest until its tempera-
ture has dropped to within 2 K (2° C) of room temper-
ature.
The workpiece must have a minimum height of
3 mm and a minimum width of 45 mm. Make sure
that the workpiece is always secured with the
clamping device.
Noise
Sound and vibration values were measured in accord-
ance with EN 62841.
www.scheppach.com
220 - 240 V~ 50 Hz
S2 5rpm* 900W
500 - 2600 rpm
0
710 Watt
1.5 - 13 mm
70 mm
320 x 305 mm
280 mm
8.3 kg
II /
2
650 nm
< 1 mW