Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
our quality controls and your maintenance, only
have it repaired by an authorized electrician.
If the supply cord of the appliance is damaged,
this has to be done by the manufacturer or his
agent or electrician in order to avoid a safety
hazard.
13. Environmental protection
End of life electrical equipment must not
be placed in household waste. Please take
it to a return point. Find out about your
nearest return point from your council or
sales outlet.
14. Trouble shooting
Problem
The motor does not
run.
The motor starts slowly
and does not reach
running speed.
Excessive motor noise. Damaged windings. Faulty motor. Have the motor checked by skilled
The motor does not
reach full power.
Motor overheats easily Overload of the motor; inadequate
Decrease in cutting
power when sawing
The saw cut is rough or
wavy
The work piece rips or
splinters
Possible Cause
Faulty motor, power supply cable
or plug.
Low power supply voltage.
Damaged windings.
Burned out capacitor.
Overloaded circuit due to lighting,
utilities or other motors.
cooling of
the motor
The saw blade is too small
(sharpened too often)
The saw blade is dull; the tooth
shape is not suited to the thickness
of the material
The cutting pressure is excessive
or the saw blade is not suited to
the application
Help
Have the machine checked by skilled
personnel.
Do not try to repair the machine
yourselves as it may be dangerous. Check
the fuses and replace them if necessary.
Ask for the Electricity Board to check the
voltage available. Have the machine
motor checked by skilled personnel.
Have the capacitor replaced by skilled
personnel.
personnel.
Do not use other utilities or motors on
the circuit to which the plunge cut saw is
connected.
Prevent overloading the motor when
cutting; remove dust from the motor to
ensure an optimum cooling of the motor
Re-adjust the end stop of the saw unit
Re-sharpen the saw blade or use an
appropriate saw blade
Use the correct saw blade
27
GB
Werbung
Inhaltsverzeichnis
