Description Of Symbols - Kawasaki K-PS 1200-55-2 Originalbetriebsanleitung

5. Description of symbols

Pay attention to all the signs and symbols shown
in these instructions and on your tool.
Make a note of these signs and symbols. If you
interpret the signs and symbols correctly, your
work with the machine will be safer and better.
Important.
Read the instructions for use before
starting the machine.
Wear safety goggles.
Wear ear protection.
Wear good quality, strong gloves.
Always use breathing apparatus when
machining materials which generate
dust.
End of life machines contain valuable
materials and therefore they should not
be placed in household waste.
We would ask you to play your part in
protecting resources and help protect
the environment by returning this
machine to a return point (if one is
available) when it reaches the end of its
life.
6. Layout
1. Speed controller
2. Front handle
3. Safety button
4. On/Off switch
5. Base plate
6. Adjusting knob for cutting depth
7. Scale for cutting depth
8. Adjusting knob for cutting angle
9. Scale for cutting angle
10. Mode selection
11. Saw blade
12. Dust suction tube
13. Motor
14. Shaft locking button
15. Cut indicator
16. Adjusting knob for track
17. Anti-kickback knob
18. Lock knob for track
19. Allen key
20. Track
21. Connecting bar for track
7. Adjusting
Caution: Prior to carrying out one of the following
adjustment steps, switch the machine off and
unplug the mains plug.
7.1 Cutting depth adjustment (Fig. 3)
• The cutting depth can be adjusted from 0 to 55
mm.
• Unfasten the cutting depth adjustment knob (6)
and set the required depth using the scale (7) and
retighten the screw.
• The dimensions on the scale show the cutting
depth without track.
7.1 Mitre settings (Fig. 4)
• The mitre square can be set from 0° to 48°.
• Unfasten the mitre adjustment knob (8) on both
sides, set the desired mitre square on the scale (9)
23
GB