Tool Specifications; Operating Controls; For Your Safety - Bosch ZF 60 Bedienungsanleitung

Tool Specifications

Dovetail jig
Order number
for Bosch routers
for other makes
Clamping height, max. [mm]
Clamping width, max [mm]
Material thickness for
dovetail (FS 10) [mm]
finger joint (FS 20)* [mm]
dowel (FS 20)* [mm]
Tool-Ø for
dovetail (FS 10) [mm]
finger joint (FS 20)* [mm]
dowel (FS 20)* [mm]
Pitch for
dovetail (FS 10) [mm]
finger joint (FS 20)* [mm]
dowel (FS 20)* [mm]
Weight, approx. [kg]
* Accessories

For Your Safety

Safe operation of this machine is possible only when
the operating instructions and the safety precautions
are read completely and the instructions contained
therein are strictly observed. Before operating the ma-
chine, ask for a practical demonstration.
The dovetail jig must be fastened on a base.
Observe safety information for router.
Allow router to run out in template after cutting.
2 609 931 304 • 03.12
ZF 60
0 603 097 000
POF 500 A, 600 ACE, 800 ACE
GOF 900 A, 900 ACE, 1200 A,
1300 ACE
Use dovetail template (FS 10)
with adapter 26 and distance
bushes 25
35
610
32
30
9 to 32
14
10
5 - 6 - 8 - 10
22
20
32 (furniture standard)
7.1
English - 1

Operating Controls

1 Clamping bolt
2 Clamping bracket
3 Dovetail template (FS 10)
4 Adjustment knob
5 Clamping lever, left
6 Template holder
7 Cutting depth gauge
8 Marking
9 Stop screw
10 Setting gauge for FS 10
11 Clamping lever, right
12 Template for finger joints and
dowels (FS 20)*
13 Setting gauge for FS 20*
Not all of the accessories illustrated or described are included as standard
delivery.
Equipment Protection
Incorrect operation can lead to damage. Therefore always ob-
serve the following regulation.
Check setting of cutting depth on router before cutting.
The cutting tools must be suitable for the type of joining. Only use
Ø 13.8 mm und Ø 17.0 mm guide bushes.
Note: The guide bushes must not extend below the templates. Also see
special Bosch template guides for the dovetailing machine.
Templates and stop screws 9 with exact adjustment increase the dimen-
sional accuracy and reproducibility of the joint.
Use only genuine accessories.
14 Groove
15 Groove nut
16 Base plate
17 Angle bracket
18 Spring
19 Washer
20 Screw
21 Angle
22 Screw
23 Washer
24 Nut
25 Distance bush
26 Adapter
* Accessories