Maintenance And Service; Maintenance And Cleaning - Bosch PLS 300 Set Originalbetriebsanleitung

OBJ_BUCH-1219-002.book Page 17 Tuesday, June 21, 2011 2:15 PM
Working Advice
Cutting Tiles (see figures H1–H3)
– Insert the tile cutter 14 into the sawing slot of the guide rail
4 above stop 15.
The arrow on the tile cutter must face you.
– Pull the tile cutter 14 over the complete tile with uniform
pressure.
– Remove the tile cutter 14 from the guide rail 4.
– Turn the locking lever 10 of the guide rail leftward and fold
the guide rail 4 upward.
Practical Advice
Problem
Tile does not break along the
cutting line
For working instructions and practical advice on the PLS 300
saw station, log onto: www.bosch-do-it.com/pls300

Maintenance and Service

Maintenance and Cleaning

If the saw station should fail or become damaged despite the
care taken in manufacture and testing, repair should be car-
ried out by an authorised customer services agent for Bosch
power tools.
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the saw station.
Cleaning
Remove dust and chips after each working procedure by
blowing out with compressed air or with a brush.
Warranty Condition
Through faulty usage, sawing into the guide rail 4 or bridge 8
can occur. No warranty claims whatsoever shall arise thereof,
as this does not affect the function of the saw station.
Bosch Power Tools
– Place the break-off cones 16 on a firm surface.
– Apply both of your thumb balls at the same time to the out-
Cause
Scoring line not continuous from front to
end
Tile cutter 14 incorrectly inserted
Surface structure of tile uneven
Break-off cones incorrectly positioned
when breaking the tile
Scoring line not continuous from front to
end
For further questions, please refer to our customer hotline:
Great Britain
Tel: +44 (0844) 736 0107
Australia, New Zealand
Phone: +61 (01300) 307 044
After-sales Service and Customer Assistance
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Our customer service representatives can answer your ques-
tions concerning possible applications and adjustment of
products and accessories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: boschservicecentre@bosch.com
Place the tile on the break-off cones in such a manner that
the break-off cones are positioned below the cutting line
and at the edges of the tile.
For diagonal cuts, the break-off cones should be posi-
tioned below the cutting line and somewhat further toward
the inside.
er sides of the tile until the tile breaks.
Corrective Measure
Apply more pressure (uniformly) when scoring the
tiles and score over the complete surface
Insert tile cutter correctly (see figure H1)
Apply more pressure (uniformly) when scoring and
increase the scoring (cutting) speed
Position break-off cones below the cutting line and
at the edges of the tile (see figure H3)
For diagonal cuts, position the break-off cones
somewhat further toward the inside
Increase scoring pressure when cutting the tiles
English | 17
1 609 929 W68 | (21.6.11)