Practical Advice - Bosch PLS 300 Set Originalbetriebsanleitung

OBJ_BUCH-1219-002.book Page 16 Tuesday, June 21, 2011 2:15 PM
16 | English

Practical Advice

The following tips are for performing length or mitre cuts (90°/45°).
Problem Cause
Cut runs out of centre Guide rail 4 not affixed
Saw blade too thin
Sawing feed too high
(apply less feed with power tool)
Angle adjustment of base plate to saw chain in-
correct
Saw blade does not run in guide roller
(see figure E)
Wood surface unsatisfactory Workpiece was sawn with the visible side facing
after cut up
Saw blade worn
Sawing feed too high
(apply less feed with power tool)
Sawing was carried out with orbital action
switched on
For working instructions and practical advice on the PLS 300
saw station, log onto: www.bosch-do-it.com/pls300
Operation
Cutting tiles
Preparing for Operation
When the sawing station is to be used for cutting tiles, the ad-
ditional PTC 1 kit is to be used.
The stop 15 is supplied as two parts, folded together.
– Before using for the first time, put the two parts of the stop
15 together, so that they cannot be taken apart after-
wards.
Lengthway Cuts (see figures F1–F3)
– Loosen the locking knob 3 a few turns.
– Turn the locking lever 10 of the guide rail leftward and fold
the guide rail 4 upward.
– Place stop 15 centred in the groove of bridge 8 and slide it
flush into base unit 1.
– Mark the desired cutting line on the workpiece.
– Place down the workpiece with the visible side up, flat
against the stop 15.
– Fold the guide rail 4 down and align the workpiece cutting
line to the scale of the stop 15.
1 609 929 W68 | (21.6.11)
Corrective Measure
Affix guide rail according to height of workpiece;
provide for firm clamping of the workpiece
Use the provided saw blade T144DP
Saw through workpiece applying less and uni-
form feed
Do not apply pressure against the side stops 5
Align base plate to saw chain and retighten
Adjust guide roller in such a manner that the saw
blade is guided (see operating instructions of
the jigsaw)
Saw workpiece with the visible side facing down
(see figure A3)
Insert new saw blade
Saw through workpiece applying less and uni-
form feed
Do not apply pressure against the side stops 5
Switch orbital action off
For further questions, please refer to our customer hotline:
Great Britain
Tel: +44 (0844) 736 0107
Australia, New Zealand
Phone: +61 (01300) 307 044
– Press down the guide rail 4 in the area of the workpiece
with your flat hand.
– Tighten the locking knob 3.
– Lock the guide rail 4 with locking lever 10.
Diagonal Cuts (see figure G)
The mitre angle can be set in the range from 45° (left side) to
45° (right side).
– Loosen locking knob 12.
– Turn the guide rail 4 left or right until the angle indicator 13
indicates the requested mitre angle.
– Tighten the locking knob 12 again.
For swift and precise adjustment of standard mitre angles,
the guide rail engages at 0° and 45°.
– For additional worksteps, see "Lengthway Cuts" on
page 16.
Bosch Power Tools