Maintenance And Storage - Homcom Fx-L31R Bedienungsanleitung

EN
ASSEMBLY INSTRUCTIONS
TIMER
hold 3 sec. to
turn on An i on
Oscillation
hold 3 sec.
to turn on
ON/OFF: The fan beeps and turns on when touch this button, all buttons flash once and set
into stand -by mode. The Light is on in breathing mode for 1 minute when turn on any
functions below.
Oscillation: A quick touch to turn on or turn off the left-right swing, hold on for 3 sec. to turn
on or turn off the up-down swing.
Speed: the default speed is 'F1' when turn on the fan, and speed increase 1 level by one
touch until 8, and back to speed 1 by one more touch. (Hold this key for 3 seconds to turn
on/off the Light).
Timer: The timer increased 1 hour by one touch until 12 hours, displays from '0H', '1H'... to
'12' in a cycle. (Hold this key for 3 seconds to turn on/off the Anion generator).
Display Screen: the screen displays the fan speed and timer. It displays '--' when turn the fan
on. The screen turns off without operation for 3 minutes, and awakens by touch on any
button.

MAINTENANCE AND STORAGE

Please press the ON/OFF key to turn off the product, unplug from the socket before cleaning
or maintenance.
Important Notice: Do not disassembly the product to clean inside of this product.
Cleaning the exterior:
Please use a clean and soft cloth or with neutral solvent to clean the exterior.
 Do not use corrosive or alkaline solvent to clean this product.
 Do not clean the inside of this product (Circuit board, motor, etc.) with any solvent, and
ensure no water reaches the control circuit in case of short circuit.
 Dry the exterior of this product.
 Do not submerge the product, power cord or plug in water in any circumstances.
 It's recommended to clean the product every 2 months.
SPEED
ho l d 3 sec. to
turn on L i ght
ON/OFF
4
CR.2025