Filling The Water Tank - Bosch sensixx B3 TDA 46 serie Gebrauchsanleitung

• This appliance is to be connected and used in
accordance with the information stated on its
characteristics plate.
• This appliance must be connected to an
earthed socket. If it is absolutely necessary to
use an extension cable, make sure that it is
suitable for 16A and has a socket with an earth
connection.
• If the safety fuse fitted in the appliance blows,
the appliance will be rendered inoperative. To
restore normal operation the appliance will
have to be taken to an authorised Technical
Service Centre.
• In order to avoid that, under unfavourable
mains conditions, phenomena like transient
voltage drops or lighting fluctuations can
happen, it is recommended that the iron is
connected to a power supply system with a
maximum impedance of 0.27 Ω . If necessary,
the user can ask the public power supply
company for the system impedance at the
interface point.
• The appliance must never be placed directly
under the tap to fill the water tank.
• Unplug the appliance from the mains supply
after each use, or if a fault is suspected.
• The electrical plug must not be removed from
the socket by pulling the cable.
• Never immerse the iron or steam tank in water
or any other fluid.
• Do not leave the appliance exposed to weather
conditions (rain, sun, frost, etc.).
12
BO SC H
1
Filling the water tank
Set the steam regulator to the
and unplug the iron from the mains!
Use only clean water from the tap without mixing
anything with it. The addition of other liquids,
such as perfume, will damage the appliance.
any damage caused by the use of the
aforementioned products will make the
guarantee void.
Do not use condensation water from tumble
dryers, air conditionings or similar. This appliance
has been designed to use normal tap water.
To prolong the optimum steam function, mix tap
water with distilled water 1:1. If the tap water
in your district is very hard, mix tap water with
distilled water 1:2.
Never fill beyond the "max" water level mark!
Before using the iron for
the first time
Remove any label or protective covering from the
soleplate.
With the iron unplugged, fill in the tank of the iron
with tap water and set the temperature control
dial to "max"
Plug in the appliance to the mains. When the
steam iron has reached the desired temperature
(pilot light switches off), start steaming by setting
the steam regulator to the maximum steam
setting and by repeatedly pressing the button
When using the steam function for the first time,
do not apply it on the laundry, as there could still
be dirt in the steam dispenser.
When turned on for the first time, your new iron
may smell and emit a little smoke and a few
particles; this will stop after a few minutes.
position
.