Residual Risks; Preparation; Control Elements - Parkside Performance Ppsbsa 20-Li C3 Originalbetriebsanleitung

GB
MT
operation, loss of control may occur, res-
ulting in personal injury.
• Hold the power tool by insulated grip-
ping surfaces, when performing an op-
eration where the cutting accessory or
fasteners may contact hidden wiring.
Cutting accessories or fasteners contact-
ing a "live" wire may make exposed met-
al parts of the power tool "live" and could
give the operator an electric shock.
Safety instructions when using long drill
bits
• Never operate at higher speed than the
maximum speed rating of the drill bit.
At higher speeds, the bit is likely to bend
if allowed to rotate freely without contact-
ing the workpiece, resulting in personal
injury.
• Always start drilling at low speed and
with the bit tip in contact with the
workpiece. At higher speeds, the bit is
likely to bend if allowed to rotate freely
without contacting the workpiece, result-
ing in personal injury.
• Apply pressure only in direct line with
the bit and do not apply excessive
pressure. Bits can bend causing break-
age or loss of control, resulting in person-
al injury.
Additional safety instructions
• Secure the workpiece. A workpiece
clamped with clamping devices or in a
vice is held more secure than by hand.
• Switch the power tool off immedi-
ately if the application tool becomes
blocked. Be prepared for high torque
reactions which cause kickback. The
application tool becomes blocked when
it becomes jammed in the workpiece
or when the power tool becomes over-
loaded.
• Always wait until the power tool has
come to a complete stop before pla-
cing it down. The application tool can
jam and cause you to lose control of the
power tool.
• Use suitable detectors to determine if
there are hidden supply lines or con-
tact the local utility company for as-
sistance. Contact with electric cables
can cause fire and electric shock. Dam-
aging gas lines can lead to explosion.
Breaking water pipes causes property
damage.
24
• Only use accessories recommended by
PARKSIDE. Unsuitable accessories may
cause electric shock or fire.

Residual risks

There will always be residual risks even if you
operate this device according to the instruc-
tions. The following hazards may occur in
connection with the type and design of this
device:
• Hearing damage if suitable ear protection
is not worn.
• Health injuries resulting from the effect of
hand/arm vibration in the event that the
tool is used over a longer period of time
or is not used and maintained properly.
• Cutting injuries
WARNING! Danger due to electromag-
netic field generated while the tool is in oper-
ation. Under certain circumstances, this field
may negatively affect active or passive med-
ical implants. In order to reduce the danger
of serious or fatal injuries, we recommend
that individuals who wear medical implants
should consult their doctor and the manufac-
turer of the implant before operating the tool.

Preparation

WARNING! Risk of injury due to uninten-
tional start-up. Only insert the battery into
the device once the device is fully prepared
for use.

Control elements

Familiarise yourself with the operating ele-
ments before using the device for the first
time.
• Drehrichtungsschalter (7)
NOTICE! Only operate the direction of ro-
tation switch when the tool has stopped!
Direction of the switch viewed from be-
hind
• Left Screw in screw, drill
• Centre Einschaltsperre
• Right Unscrew screw
• Gear selector switch (6)
CAUTION! Only operate the gear se-
lector switch when the tool has stopped.
• 1 Screw
To use the screw operating mode,
switch the slip clutch on. Set the func-
tion selector switch (5) so that the ar-