Connection; Maintenance And Care - Led2Work Tubeled 40 Ii Basic-Line Ac Betriebsanleitung

5 | Connection

On the light is an input for about a M12 connector S-type encoded. About this jack and with suitable connection material
the light is connected with a 220–240V AC electric power supply system.
Suitable connection material, cables and accessories can be found in the accessory range of LED2WORK.
PIN assignment of the M12 connector is as follows:
PIN assignment
PIN 1 = not connected
PIN 2 = external conductor/phase (L)
PIN 3 = neutral conductor (N)
PIN 4 = protective earth conductor (PE)

6 | Maintenance and Care

The LED light is maintenance-free. Do not make any alterations to the light (except according to the mounting information
contained in this manual).
The LED light sources mounted in the light are connected to the luminaire housing in a special way (thermal coupling)
and may react sensitively to electrostatic discharges (ESD). Improper replacement of the illuminant or other compo-
nents may impair the tightness of the light. That is the reason why repairs may only be carried out by the manufactu-
rer or by persons authorised and qualified by the manufacturer.
Turn off the light before cleaning and let it cool down completely. Clean the outside of the light with a soft, dry and clean
cloth. To remove excess dirt, moisten the cloth with water. Never use aggressive cleaning agents, as these may cause
discolouration of the housing.
10 | BA TUBELED_40 II Basic-Line AC . BA 03/2026
Schematic drawing of M12 S-type encoded
For the installation on the power supply system the light must be electrically load-free.
This means that if the light is connected directly to a machine or a 220–240V AC power
supply, these must be switched off and load-free for installation, otherwise the LEDs
may be destroyed.
Do not open the light!
No liability is assumed for damages resulting from the use of unsuitable cleaning agents.
brown
black
blue
green/yellow