Axkid Minikid Bedienungsanleitung Seite 12

Allowed and disallowed positioning of the child car seat.
Front passenger seat (no active airbag)
Front passenger seat (active airbag)
Forward facing seat with 3-point seat belt
Seat with 2-point seat belt
Side facing seats
Rear facing seats
Never use this child seat in a car that is not equipped with an
ECE Reg 16 approved three-point belt.
Rear-facing 0-25 kg with seat belt & tethers
Positioning the child restraint
The easiest way to lift the Minikid into the vehicle is with its back first. Place the child restraint in
2
the vehicle with the back of the restraint facing the front of the vehicle.
The heels (J) should be sitting over the edge of the vehicle seat. The indented vertical line (K)
3
on the heel should align vertically with the end of the vehicle' s seat. If installing in a small vehicle,
or if your child does not require extra leg room, you can instead place the heel upon the vehicle' s
seat this will also achieve a more reclined position.
Note: When installing Minikid in the front seat it is possible, but not crucial, for the back of the restraint
to have contact with the dashboard.
To adjust the angle of the child restraint, press the recline adjustment lever (G) to select one
4
of the five reclining positions. Always choose the most upright position as possible, however
your child must be able to hold their head up on its own, and there should be enough recline to
ensure your child' s head does not fall forward when sleeping. The rule of thumb is that the older the
child grows, the more upright the seat can be installed. Please note that once the installation of the
Minikid is complete, it will be somewhat more reclined as it sinks into the vehicle' s seat from tightening
seat belts and tether straps.
Never install a child restraint in a passenger seat
where an active airbag is fitted.
5
Yes
NO
Yes
NO
NO
NO