Tips And Recommendations; Questions On The Io Lighting Receiver; Replacing A Lost Or Broken Somfy Io Control Point; Restoring The Original Configuration - SOMFY Lighting Receiver io Installationsanleitung

Installation guide
7.2.2 Multiple control
Multiple control: an io Lighting Receiver is controlled by
several Somfy io local control points.
1) Press the PROG button on the programmed control point
(A) until the light comes on and then goes out: the io
Lighting Receiver will be in programming mode for 10
mins.
2) Briefly press the PROG button on the Somfy io local
control point (B) to be added: the light will come on and
then go out; the io control point has been added.
- Repeat these two steps to add each Somfy io local
control point.

8. TIPS AND RECOMMENDATIONS

8.1 Questions on the io Lighting Receiver?

Observations
Pressing a button on the
control point does not cause
any reaction on the light
Nothing operates

8.2. Replacing a lost or broken Somfy io control point

Refer to the corresponding guide.
8.3. Restoring the original configuration
This reset is carried out with a Somfy io local control
point.
This reset deletes all the control points.
Only cut the power to the io Lighting receiver to be
reset.
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for 5 to 15 seconds.
3) Cut the power supply for 2 seconds.
4) Switch the power supply back on: the light will flash
slowly.
5) Hold down the PROG button: the light will come on and
then go out; then it will come back on a few moments later.
The io lighting receiver will be in factory configuration.
- Repeat the procedures from the section "
Copyright © 2009 Somfy SAS. All rights reserved.
Possible cause
The light has blown.
The control point has not been
programmed into the io Lighting
Receiver
The batteries in the control point are
depleted
Radio interference is preventing the
Somfy io local control point and io
Lighting Receiver from working.
The control point used is not
compatible with the io Lighting
Receiver
The power supply is faulty.
The light has blown.
The light or bulbs linked with the io
Lighting Receiver is (are) in excess of
500 W.
Commissioning"
Lighting receiver io
1 2
PROG. A PROG. B
Solution
Replace the light.
Follow the procedure for adding a
Somfy io local control point.
Replace the batteries
Turn off any radio equipment nearby.
Ensure the two products are
compatible.
Check the power supply.
Replace the light.
Ensure that the bulbs linked with the io
Lighting Receiver do not exceed 500
W in total.
1 2
OFF
2 seconds.
3 4
OFF
2 seconds.
5
PROG. A
+
10 min.
5 seconds.
ON
15 seconds.
ON
29