Omnitronic MRS-1202USB Bedienunganleitung Seite 16

AUX SEND MASTER.
22 Button PHANTOM 48V with LED
When engaged, a 48 V phantom power is switched on for all microphone inputs MIC which most
condenser microphones require. Caution! If the phantom power is switched on, no unbalanced
microphones must be connected. Otherwise, these microphones may be damaged.
23 Level control CTRL RM/PHONES
For adjusting the monitoring level at the monitor outputs CTRL RM OUT and PHONES.
24 Power indicator
25 Level control MASTER AUX SEND
Level control for the total signal of the effect way at the output AUX SEND.
26 LED level indicators
4-digit LED level indicators for the level of the master signal or the monitoring signal selected with
the buttons TAPE/USB TO CTRL RM/PHONES and FX TO CTRL RM.
27 Master fader
Level control for the master signal which is sent to the outputs MAIN OUT, CD/TAPE OUTPUT and
the USB port and can be monitored via the outputs CTRL RM OUT and PHONES.
28 Power switch
29 Power input
Connect the included power supply unit here.
30 USB port
For connection to a computer. The USB port allows transmission of digital audio signals in both
directions between the mixer and the computer.
Use as input: Press the button TAPE/USB TO MIX to switch the audio signal coming from the
computer to the master channel; with the button TAPE/USB TO CTRL RM/PHONES pressed, the
audio signal can be monitored via the monitor outputs CTRL RM OUT and PHONES.
Use as output: The USB port sends the digital master signal.
16