Omnitronic MRS-1202USB Bedienunganleitung Seite 15

1 Microphone input MIC IN
Balanced XLR connector for the mono channels to connect a microphone. For condenser
microphones, a 48 V phantom power can be activated with the PHANTOM 48V switch.
2 Input LINE IN
Balanced 6.3 mm jack for the mono channels to connect audio units with line level (e.g. musical
instrument).
3 Input LINE IN
Balanced 6.3 mm jacks L/R for the stereo channels to connect audio units with line level (e.g.
musical instrument). When connecting a mono device, only use the upper jack L/MONO.
4 Control GAIN
For adjusting the input amplification of the microphone and line input of the mono channels.
5 Tone controls
For adjusting the high frequencies (HIGH), mid-frequencies (MID) and bass frequencies (LOW).
6 Button 75 Hz
Button for the low cut filter for the mono channels; when the button is pressed, unwanted signal
parts below 75 Hz (e. g. impact noise) will be suppressed.
7 Button -10/+4
To match the level for units with a line output level which is too low for the stereo channels; with the
button engaged, the input level is boosted.
8 Control AUX SEND
To add the channel signal to the effect send way which is available at the output AUX SEND.
9 CLIP indicator
10 Panorama control
To place the mono signal in the stereo sound for the mono channels.
11 Balance control
For adjusting the balance left/right for the stereo signal for the stereo channels.
12 Level control
To add the channel signal to the master signal.
13 Output MAIN OUT
Main output (6.3 mm jacks L/R, unbal.) for the master signal for connecting an amplifier or a
second mixer.
14 Output CTRL RM OUT
Output (6.3 mm jacks L/R, unbal.) for connecting an amplifier of a monitor system.
15 Output AUX SEND
Mono output (6.3 mm jacks, unbal.) for connecting the input of an effector.
16 Headphones output
6.3 mm jack for connecting stereo headphones (min. impedance 8 Ω).
17 Input CD/TAPE INPUT
Stereo input (RCA L/R) for connecting the output of a recorder or another playback unit (e.g. CD
player).
18 Output CD/TAPE OUTPUT
Stereo output (RCA L/R) of the master signal for connecting the input of a recorder or an amplifier.
19 Button TAPE/USB TO MIX
With the button pressed, the signal at the input CD/TAPE INPUT and the USB port is sent to the
master channel.
20 Button TAPE/USB TO CTRL RM/PHONES
With the button pressed, the signal at the input CD/TAPE INPUT and the USB port is sent to the
monitoring outputs CTRL RM OUT and PHONES and indicated by the LED level indicators.
21 Button FX TO CTRL RM
With the button pressed, the signal of the effect way is sent to the monitoring outputs CTRL RM
OUT and PHONES and indicated by the LED level indicators, ahead of the output control MASTER
15